Denon AVR-E400 Owner's Manual page 25

1
Prepare the included Setup and
measurement microphone
Mount the Setup and measurement microphone on
a tripod or stand and place it in the main listening
position.
When placing the Setup and measurement microphone, adjust
the height of the sound receptor to the level of the listener's
ear.
Setup and
Sound receptor
measurement
microphone
If you do not have a tripod or stand, set up the microphone on, for
example, a seat without a back.
NOTE
• Do not hold the Setup and measurement microphone in your hand
during measurements.
• Avoid placing the Setup and measurement microphone close to a
seat back or wall as sound reflections may give inaccurate results.
DVD
2
Set up the subwoofer
If using a subwoofer capable of the following
adjustments, set up the subwoofer as shown below.
For details, see your subwoofer's manual.
n When using a subwoofer with a direct mode
Set the direct mode to "On" and disable the volume adjustment
and crossover frequency setting.
n When using a subwoofer without a direct mode
Make the following settings:
• Volume : "12 o'clock position"
• Crossover frequency : "Maximum/Highest Frequency"
• Low pass filter : "Off"
• Standby mode : "Off"
3
Set up the zone mode
MAIN
Press to switch the zone mode.
MAIN
lights.
Press MAIN
22
Set up speakers (Audyssey® Setup)
Preparation
4
Connect the Setup and measurement microphone to
the SETUP MIC jack of this unit.
When the Setup and
measurement microphone is
connected, the following screen is
displayed.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
• Here, we explain setup using the example of 5.1-channel speaker
playback.
For settings other than 5.1-channel speaker playback, select
"Amp Assign" and perform step 3 to 6 of "Set up "Amp Assign""
(vpage 86).
If unused channels are set with "Channel Select", measuring time
can be shortened. For setting, perform steps 7 to 11 of "Set up
"Channel Select"" (vpage 87).
v See overleaf