Denon AVR-E400 Owner's Manual page 107

Volume
Set the MAIN ZONE (room where the unit is located) volume setting.
Setting items
Scale 0 – 98 : Display in the range 0 (Min) to 98.
–79.5dB – 18.0dB : Display ---dB (Min), in the range –79.5 dB to 18.0 dB.
Set how volume is
displayed.
• The "Scale" setting is applied also to the "Limit" and "Power On Level"
display method.
• The "Scale" setting applies to all zones.
Limit 60 (–20dB) / 70 (–10dB) / 80 (0dB)
Make a setting for Off : Do not set a maximum volume.
maximum volume.
Power On Level Last : Use the memorized setting from the last session.
Define the volume setting Mute : Always use the muting on condition when power is turned on.
that is active when the 1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
power is turned on.
Mute Level Full : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
Set the amount of
attenuation when muting –20dB : The sound is attenuated by 20 dB down.
is on.
DVD
Default settings are underlined.
Setting details
104
Audyssey
Set Audyssey MultEQ ® , Audyssey Dynamic EQ ® and Audyssey Dynamic Volume ® . These can be selected
after Audyssey ® Setup has been performed. For additional information on Audyssey technology, please
see page 142.
NOTE
• If you have not performed Audyssey ® Setup, or if you change the speaker settings after performing
Audyssey ® Setup, you may not be able to select Dynamic EQ/Dynamic Volume.
In this case, either perform Audyssey ® Setup over again or perform "Restore..." (vpage 27) to return
to the settings after Audyssey ® Setup was run.
• When HD Audio for which the sampling frequency exceeds 96 kHz is played back, the "Audyssey"
cannot be set.
Setting items
MultEQ ®
Audyssey : Optimize the frequency response of all speakers.
MultEQ ® compensates for
Audyssey Byp. L/R : Optimize frequency response of speakers except
both time and frequency front L and R speakers.
Audyssey Flat : Optimize frequency response of all speakers to flat
characteristics of the
listening area based on response.
Audyssey ® Setup
Graphic EQ : Apply frequency response set with "Graphic EQ"
measurement results. (vpage 105).
Off : Turn "MultEQ ® " equalizer off.
Selection is done from three
types of compensation
curves. We recommend the
"Audyssey", "Audyssey Byp. L/R" and "Audyssey Flat" can be selected
"Audyssey" setting.
after Audyssey ® Setup has been performed. "Audyssey" is automatically
MultEQ ® is the prerequisite
selected after performing Audyssey ® Setup. When "Audyssey", "Audyssey
function for Dynamic EQ
Byp. L/R" or "Audyssey Flat" is selected,
and Dynamic Volume.
NOTE
When using headphones, "MultEQ ® " is automatically set to "Off".
"MultEQ ® ", "Dynamic EQ" and "Dynamic Volume" settings are stored for each input source.
Audio
Default settings are underlined.
Setting details
illuminates.
v See overleaf