Start New Setup - Alesis MICRON Reference Manual

6
Programs
note including and lower than the note you select will use the setup's
existing part.
To select the split point, turn the control knob or play a key. You
can use the [octave] buttons if your desired split point is outside
of the current key range.
5. add part. The program is added as a brand new part across
the entire keyboard range. All other part parameters are set to
their default values as well.

4. Start New Setup?

Pressing the control knob at this option creates a new setup named
with the program's name and a "+" in front (e.g. "+Repeater" or
"+TranceTube") and, if a setup with this name already exists, a
number at the end (e.g. "+Repeater2" or "+TranceTube2"). After
doing this, you'll notice that the program mode button is no long
lit; the Micron has switched into setups mode.
If you have not chosen to start a new setup, then you are still in
programs mode. Turning the control knob further clockwise
scrolls through the many program editing parameters, as follows:
62