Resetting; Partial Reset - Icom ID-31A Instruction Manual

■ Resetting

The display may occasionally display
erroneous information (e.g. when first
applying power). This may be caused
externally by static electricity or by oth-
er factors.
If this problem occurs, turn OFF power.
After waiting a few seconds, turn ON
power again. If the problem persists,
perform either or both procedures be-
low.

• Partial reset

Use Partial reset if you want to initial-
ize the operating conditions (VFO fre-
quency, VFO settings, menu contents)
without clearing the memory contents,
call sign memories or repeater lists.
• All reset
Reset the CPU, if the internal CPU mal-
functions due to static electricity, etc. All
reset clears all programming and re-
turns all settings to their defaults.
D Partial reset
q Hold down for 1 second to turn
OFF power.
w While holding down [V/MHz]
then hold down for 1 second to
turn ON power to partially reset the
transceiver.
• "PARTIAL RESET" appears when
tially
resetting the CPU.
RESETTING
D All reset
q Hold down
OFF power.
, w While holding down [V/MHz]
[M/CALL] and D-pad(Ent), then
hold down
ON power to reset the CPU.
par-
• "ALL RESET" appears when resetting
the CPU.
7
1
2
for 1 second to turn
3
4
,
5
for 1 second to turn
6
7
8
9
10
11
12
13
14
15
16
17
18
19
50