Grizzly G0638 Owner's Manual page 27

3.
Apply the 10 x 50 x 2000mm gaskets to the
underside of the collection drum lids (see
Figure 34).
Figure 34. Applying dust collection drum lid
gasket.
4. Install the drum lid latches on the upper part
of each collection drum assembly with (12)
#10-24 x ⁄ " Phillips head screws and (12)
3
8
#10-24 hex nuts (see Figure 35).
Figure 35. Collection drum lid latch installed.
5.
To prevent a vacuum leak in the collection
drums, use (12) #10-24 x
screws and (12) #10-24 hex nuts to plug
the holes in the lower half of the collection
drums.
G0637/G0638 Cyclone Dust Collector
⁄ " Phillips head
3
8
6.
Attach each set of four bag holder panels with
the (24) #10-24 x
and (24) #10-24 hex nuts to make two dust
collection drum bag holders (see Figure 36).
Figure 36. Dust collection drum bag holder
assembled.
7.
Attach two rubber handles to the inside of
each bag holder assembly with (4)
⁄ " hex bolts, (8) ⁄
5 1
8 4
20 hex nuts.
8.
Insert the 640 x 1200mm dust collection bags
and bag holders into the drum collection
assemblies, as shown in Figure 37.
Figure 37. Dust collection bag and bag holder
inserted into collection drum assembly.
3 ⁄ " Phillips head screws
8
⁄ "-20 x
1
4
" flat washers, and (4)
1
-25-
⁄ "-
4