Grizzly G0638 Owner's Manual page 26

Small Cyclone Funnel and Funnel
Port
1.
Apply the 3 x 6 x 2200mm gasket to the larg-
er, top end of the small cyclone funnel, then
place the cyclone funnel upside down on the
floor.
Note: Use a clean covering on the floor to
protect the gasket.
2.
Apply the 3 x 6 x 736mm gasket to the top of
the funnel port and place this upside down on
top of the cyclone funnel.
3. Attach the small cyclone funnel and funnel
port with (6) ⁄ "-18 x 1
5
16
flat washers, and (6)
4. With assistance, attach this assembly to the
bottom of the large cyclone funnel with (9)
⁄ "-18 x 1 ⁄ " hex bolts, (18)
5 1
16 4
and (9) ⁄ "-18 hex nuts (see Figure 31).
5
16
Small
Cyclone
Funnel
Figure 31. Small cyclone funnel and funnel port
attached.
-24-
⁄ " hex bolts, (12) ⁄ "
1 5
4 16
⁄ "-18 hex nuts.
5
16
⁄ " flat washers,
5
16
Funnel
Port
Dust Collection Drum Assemblies
1.
For each lower collection drum cylinders,
attach the casters to the bottom using (4)
16 hex nuts, (4) ⁄
3
8
lock washers (see Figure 32).
Figure 32. Dust collection drum casters installed.
2. Connect each upper and lower collection
drum cylinder with a collection drum clamp
and use (1) ⁄ "-18 x 3" hex bolt and (1)
5
16
18 hex nut to tighten the clamp (see Figure
33).
Figure 33. Installing drum clamp around dust
collection cylinders.
G0637/G0638 Cyclone Dust Collector
3
" flat washers, and (4)
⁄
5
16
⁄ "-
8
⁄ "
3
8
"-