Grizzly G0638 Owner's Manual page 23

Note: Orient the two assemblies so that the
large, round intake port of the intake barrel
is NOT directly underneath the rectangular
outlet port of the blower housing. The outlet
port will connect to the canister filters and will
not allow room for attachment of the intake
ducting to the intake port.
4.
Attach the two assemblies with the (12)
18 x ⁄ " hex bolts and (12)
3
4
(see Figure 21).
Figure 21. Securing intake barrel assembly to
blower housing assembly.
Note: When installing the two bolts above the
intake port of the intake barrel, use duct tape
on the bottom of your wrench. This will hold
the bolts in the wrench while inserting them in
place (see Figure 22).
Figure 22. Using tape on a wrench in a tight
spot.
G0637/G0638 Cyclone Dust Collector
⁄ "-
5
16
⁄ " flat washers
5
16
Mount Blower/Intake Assembly to
Upper Stand and Install Lower Stand
Legs
1. Lower the blower/intake assembly into the
upper stand assembly so that the cyclone
mounting brackets align with the mounting
holes of the upper stand braces (see Figure
23).
Cyclone
Mounting
Brackets
Figure 23. Mounting blower/intake assembly to
upper stand.
2.
Secure the mounting brackets to the upper
stand with (8) ⁄ "-16 x
3
8
flat washers, and (8)
3. With assistance and the power lifting equip-
ment, raise the entire assembly high enough
to install the lower stand legs.
4.
Slide the four lower stand legs onto the bot-
toms of the upper stand legs—do NOT install
the fasteners yet.
5.
Slowly lower the weight of the assembly onto
the lower stand legs.
Note: To keep the assembly stable while
completing the next steps, keep the power
lifting equipment engaged but not lifting.
⁄ " hex bolts, (16) ⁄ "
3 3
4 8
⁄ "-16 lock nuts.
3
8
-21-