Base And Supports - Grizzly G0583 Instruction Manual

Base and Supports

Components and Hardware Needed:
Base ...................................................................1
Casters ...............................................................4
Round Support ...................................................1
Rectangle Support ..............................................2
Impeller/Separator ..............................................2
Handle ................................................................1
Hex Bolts ⁄ "-18 x ⁄
5 1
16 2
Hex Bolts M6-1.0 x 10 ........................................4
Acorn Nuts ⁄ "-18 .............................................4
5
16
Flat Head Screws M6-1.0 x 10 ...........................2
Phlips Screw 10-24 x
Flat Washers ⁄ "-18 ...........................................2
5
16
Tools Needed:
Wrench or Socket 12mm ....................................1
#2 Phillips Screwdriver .......................................1
To assemble the dust collector base:
1. Make sure the dust collector motor is
unplugged!
2.
Install the the casters with the four
acorn nuts and washers. (see Figure 6).
Figure 6. Installing casters.
G0583 1 HP Canister Dust Collector
" ........................................6
⁄ " ................................... 1
3
8
5
4. Place the round and rectangle supports on
QTY
the base and install with six
bolts (see Figure 7).
Figure 7. Impeller/separator supports.
5. Align the impeller/separator assembly with
the supports, and install six
bolts (see Figure 8).
6. Position the elbow as shown in Figure 8,
and secure it in place with the #10-24 x
phlips head screw.
⁄ "-18
16
7. Position the handle as shown in Figure 8,
and secure it in place with two M6-1 x 10 flat
head screws.
Figure 8. Impeller/separator attached to base.
⁄ "-18 x ⁄ " hex
5 5
16 16
⁄ "-18 x ⁄ " hex
5 1
16 2
⁄ "
3
8
-13-