Setting Up - Fisher M-Scope ID EDGE Operating Manual

SETTINg UP

Your Fisher ID EDgE is built to last for years. Handle it carefully, care
for it regularly, and it will give you years of dependable service.
The ID Edge requires little assembly.
Touch pads
Foam
Padded
hand grip
Arm rest
1. Unpack your ID EDgE carefully and save the
carton: it may come in handy if you ever have to
return the instrument for service.
2. Slip the middle assembly into the upper handle.
3. Adjust the stem length and coil angle so that the
search coil rests flat on the ground about 6 to 12
inches in front of and slightly to the right of your right
foot (to the left of your left foot for left handers). Your
arm should be straight and relaxed, the grip held
loosely (see drawing on next page). The stem length
is adjusted by loosening the lower lock nut and
allowing the spring clip to snap into one of the
Headphone Jack: located on
the back of the control panel.
Control
housing
Middle
stem section
Search
coil cable
lock nut
Upper
lock nut
Upper stem
8" Spider Coil
Nylon wing nut
Lower
(with replaceable
Duro-Neoprene
bushings)
Adjustable,
fiberglass
filled, nylon
lower stem
2