Using Your Cooktop - Fisher & Paykel CG302D User Manual

Using your cooktop

8
High
Burner
indicator
Identify the dial of the burner you want to
1
use.
High
After the burner has lit, keep the dial held
3
down for 3 more seconds (a), then release.
You may now adjust the flame
anywhere between High and Low (b).
Do not adjust or leave the dial
between High and off (
On dual wok burners (some models
only) you can use the inner ring of
flame by itself. See the illustration
opposite.
Important!
Turn the burner off (
There's a strong gas smell.
The flame has been blown out by a draught or
extinguished by a spill.
There is no clicking/sparking or there is clicking/
sparking, but a burner or burners won't light.
The flames don't burn all the way around a
burner, or some flames flicker.
Off
Low
3 secs
a
b
Low
o
).
o
) and see 'Troubleshooting' for what to do next if you experience any of the following:
High
Press down (a) then turn anti‐clockwise to High (b).
2
The ignitors will start clicking as they
spark.
If there is no clicking, there is no spark
to light the burner. Turn the dial back to
o
off ( ) and see 'Troubleshooting' .
When you have finished cooking, turn the dial
4
clockwise back to off (
Check that the burner has gone out.
Before leaving the kitchen, check that all
burners have been turned off.
The flame goes out when you release the dial
3 seconds after lighting.
The flame is yellow or yellow‐tipped rather
than blue.
The flames are too large, small, irregular,
noisy or lift away from the burner.
a
b
o
).