Installing The Wa555 Grip/Switch Cover Accessory On The Sc2; Receiver Mounting; Table Mounting A Receiver; Rack Mounting A Single Receiver (Figure 4) - Shure SC User Manual

ENGLISH
INSTALLING THE WA555 GRIP/SWITCH COVER ACCESSORY
ON THE SC2
The SC2 transmitter is supplied with an external sleeve accessory
(WA555) that prevents accidental movement of the microphone controls,
without affecting RF performance. It also provides the microphone with a
"grip" feel. To install the grip/switch cover, proceed as follows:
1. Unscrew the battery cover.
2. Slide the cover over the microphone handle "lip" end downward. The
cover fits snugly and requires additional pressure for the last 25.4 mm
(1 in.) of travel.
3. Reinstall the battery cover.

RECEIVER MOUNTING

Table Mounting a Receiver

To mount the SC4 receiver on a flat, horizontal surface such as a table,
attach the four adhesive bumpers to the bottom corners and place it on the
surface.

Rack Mounting a Single Receiver (Figure 4)

1. Remove the two screws on one side of the SC4 receiver.
2. Position the WA500 mounting bracket over the holes, and secure the
bracket to the receiver with the two screws. Repeat this process for the
other side of the receiver with the other mounting bracket.
3. Insert the plastic plugs into the hole in the front of the rack ears.

Rack Mounting Two Receivers Side by Side (Figure 5)

1. Place the two SC4 receivers next to each other, with the front panels
facing you.
2. Remove the two screws on the outer side of each receiver.
3. Position each WA502 mounting bracket over the screw holes, and
secure the bracket to the receiver with the two screws.
4. Remove the screws on the inner side of each receiver.
5. Place a link bar so that its threaded vertical hole is positioned toward
the front of the receiver on your left, and secure the bar with the screws.
Place the other link bar so that its threaded vertical hole is positioned
toward the rear of the receiver on your right, and secure it with the
screws.
6. Position the receivers so that the link bars line up one on top of the
other.
7. Using the two small screws supplied with the link bars, insert one screw
from the top into the threaded vertical hole located at the front of the
link bar. Then, insert the other screw from the bottom into the threaded
vertical hole located at the rear of the link bar.
NOTE: The SC4 receiver is designed to meet the industry-recognized HR
(Half-Rack) modular format. To rack mount two SC4 receivers side-by-side,
use two dual unit rack mount kits. For additional information on receiver
rack mounting, contact Shure Customer Service at (800) 866-2553.
– 10 –
ENGLISH