Chapter 1 - Agency Approvals; Label Locations; Safety & Rf Approvals By Country; Rf Terminal-802.11G And/Or Bluetooth - Honeywell 5900 RFID User Manual

1
Agency Approvals

Label Locations

Optimus 5900 RFID mobile computers meet or exceed the requirements of all applicable standards
organizations for safe operation. However, as with any electrical equipment, the best way to ensure safe
operation is to operate them according to the agency guidelines that follow. Read these guidelines
carefully before using your mobile computer.
Compliance Label
Safety & RF Approvals by Country:
Country
U.S.A.
Laser Safety Statement: This device has been tested in accordance with and
complies with IEC 60825-1:2007 and 21 CFR 1040.10 and 1040.11, except for
deviations pursuant to Laser Notice No. 50, dated June 24, 2007. LASER
LIGHT, DO NOT STARE INTO BEAM, CLASS 1 LASER PRODUCT.
Caution - use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
RF Terminal—802.11g and/or Bluetooth
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Safety
UL60950-1
RF (Radio)
FCC Part 15, Sub part B, Sub part C
LASER LIGHT. DO NOT STARE INTO BEAM
CLASS 1 LASER PRODUCT
IEC 60825-1:2007
Complies with 21 CFR 1040.10 and 1040.11
except for deviations pursuant to Laser
Notice No. 50, dated June 24, 2007.
1 - 1