Suspend Mode; Changing The Memory Allocation; Care And Cleaning Of The Optimus 5900 Rfid Terminal - Honeywell 5900 RFID User Manual

Hard resets automatically launch a soft reset as part of the boot process if there are CAB files present.
You would perform a Hard Reset (instead of a Soft Reset) when you want to ensure the RAM memory is
also cleared. RAM memory stores settings for Internet Explorer, Outlook, and other Microsoft
applications.
Note: Set the time and date after each hard reset to ensure that the system clock is accurate. Double-click the date
on the command bar to open the Clock setting and set the time and date.

Suspend Mode

Suspend Mode suspends terminal operation. The terminal appears to be "off" when in Suspend Mode.
The terminal is programmed to go into Suspend Mode automatically when inactive for a specified period
of time. You can set this time period in the Power setting.
To suspend operation, press the orange Power button to put the terminal in Suspend Mode. To wake
the device, press the Power button. You may also press the front or rear scan keys to wake a suspended
device.
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Power button, the main battery might be too low to
resume operation. To check, remove the battery and install a fully charged battery or connect the terminal
to a Optimus 5900 RFID charging peripheral.

Changing the Memory Allocation

You can adjust file storage versus program memory in System Properties.
1. Tap Start > Settings > Control Panel > System > Memory tab.
2. Move the slider to adjust the memory allocation and tap OK. The changes take effect immediately.

Care and Cleaning of the Optimus 5900 RFID Terminal

When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-free
cloth. The terminal can be cleaned with a damp cloth.
3 - 15