Watching Tv; Turning On/Off The Power; Initial Setup - Sharp LC-42SB45U Operation Manual

Watching TV
Turning On/Off the Power
) POWER
00
"UTE
o
q
CH
d
MENU
o
"PUT
o
,
POWER
(On/Standby)
Press POWER on the 1V, or POWER on the remote control unit to turn
the power on.
• POWER indicator (Green): The TV is on. (After a few seconds, a window
appears with sound.)
Press POWER on the 1V, or POWER on the remote control unit again
to turn the power off.
• The TV enters standby and the image on the screen disappears.
• POWER indicator (Red): The TV is standby.
1mB
• If you are not going to use this TV for a long period of time, be sure to remove
the AC cord from the AC outlet.
• Weak electric power is still consumed even when the TV is turned off.
• If there is no signal input for 30 minutes, the power will turn to standby mode
automatically.
When you turn on the 1V for the first time, it will
automatically memorize the broadcasting channels
available in the region where you live. Perform the
following steps before you press POWER on the
remote control unit.
1. Insert the batteries into the remote control unit. (See page 8.)
2. Connect the antenna cable to the TV. (See page 8.)
3. Plug in the AC cord to the AC outlet. (See page 7.)
Initial Setup
QijlQ
8
o .
0
00001
••••
=1
Air/Cable (Antenna setting)
Make sure what kind of connection is made with your TV
when selecting "Air" or "Cable".
3
Press JJ../T to select "Air" or "Cable".
Press the B button to continue.
Language (Language setting)
Select from among 3 languages: English, French and Spanish.
1
Press
ll/T
to select the desired language listed on the
screen, and then press theB button.
2
If you are connecting to a HD cable box, press the A
button to exit. If you are connecting to Antenna or Cable
from wall outlet, press the B button to next step.
4
Press the A button to finish.
ImD
• Auto programming may take up to 20 minutes to complete.
Digital channels will take longer than Analog to find and
program. Please wait until you see the Auto programming
complete message. The TV will then switch automatically
to the first channel found.
@·13