Table of Contents
Advertisement
Configuration
(Standalone)
Sound-Active
Mode
Sound Sensitivity
Automatic Mode
Program Speed
Page 12 of 19
1.
Set the product in one of the standalone modes to control without a DMX
controller.
2.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode (Static, Auto, or
Sound-Active) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
To enable the Sound-Active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER> and Snd1 (4-color) or Snd2 (15-color) shows on the display.
3.
Use <UP> or <DOWN> to select the desired Sound-Active program.
4.
Press <ENTER>.
To set the sound sensitivity, follow the instructions below:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> or <DOWN> to select the desired sound sensitivity (u 0–u100).
3.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To enable the Automatic mode, do the following:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER> and P 1–P 4 shows on the display.
3.
Use <UP> or <DOWN> to select the desired auto program:
·
P 1 - 4-color snap
·
P 2 - 4-color fade
·
P 3 - 15-color snap
·
P 4 - 15-color fade
4.
Press <ENTER>.
To set the auto program speed, follow the instructions below:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> or <DOWN> to select the desired auto program speed
S 1–S100 (slow to fast).
3.
Press <ENTER>.
SlimPAR™ QUAD 3 IRC User Manual Rev. 2
Advertisement
Table of Contents
