Error Messages - Chauvet Legend 1200E Wash User Manual

Operating Instructions

Error Messages

Message
Lamp Startup Fail
Lamp Hot Protection
Lamp Hot Power Off
Maintenance Fixture
Fan1 Error
Fan2 Error
Fan3 Error
Fan4 Error
CPU-B Error
CPU-C Error
CPU-D Error
CPU-E Error
Pan Home Sensor Error The pan has failed to reset/home properly; check sensor, magnet, or pan lock
Pan Encode Error
Tilt Home Sensor Error
Tilt Encode Error
Color 1 Reset Fail
Color 2 Reset Fail
Cyan Reset Fail
Magenta Reset Fail
Yellow Reset Fail
3200K Filter Reset Fail
Zoom Reset Fail
Memory Initial Reset Fail Memory malfunction or miscommunication; chip: 24C256
Temperature Sense Fail
Lamp On Over 700 Hour
Legend™ 1200E Wash User Manual
When the error alert icon appears on the home screen, press
<ENTER> to view the error information. Please see the chart
below for further explanation.
Once an error has been resolved, you may perform a fixture reset to remove
the message from the home screen.
Description
Failed to strike the lamp after 1 minute (1 attempt).
The lamp has reached a temperature between 105° C and 109° C; the lamp will
operate at half power while at these temperatures to attempt to bring the temperature
to normal levels
The lamp has reached 110° C or higher, and has been turned off as a safety
precaution
The user-selected time for maintenance has been reached
Fan 1 has malfunctioned
Fan 2 has malfunctioned
Fan 3 has malfunctioned
Fan 4 has malfunctioned
Communication malfunction with CPU-B
Communication malfunction with CPU-C
Communication malfunction with CPU-D
Communication malfunction with CPU-E
The pan encoding/optical sensor has malfunctioned
The tilt has failed to reset/home properly; check sensor, magnet, or tilt lock
The tilt encoding/optical sensor has malfunctioned
The color wheel 1 has failed to reset/home
The color wheel 2 has failed to reset/home
The dichroic shutter for cyan has failed to reset/home
The dichroic shutter for magenta has failed to reset/home
The dichroic shutter for yellow has failed to reset/home
The dichroic shutter for 3200 K CTO Filter has failed to reset/home
The zoom has failed to reset/home
The temperature sensor is not responding
The lamp has been operating for over 700 hours, please consult the lamp
manufacturer's rating for the lamp This can be reset in the control panel of the fixture
20 8/13/2009 10:55 AM