Menu Map - Chauvet Legend 1200E Wash User Manual

Operating Instructions

Menu Map

Main Function Sub Function
DMX Address
DMX Channel Mode
DMX Functions
View DMX Value
Pan Inverse
Tilt Inverse
Fixture Settings
Bl.o. P/T Moving
Bl.o. Color Change
On/Off
State/Power On
Off Via DMX
On if DMX On
Off if DMX Off
Lamp Settings
Cooling Mode
Ignition Delay
Low Power Delay
Display Inverse
Back Light Auto Off Yes/No
Display Settings Back Light Intensity 1~10
Temperature Unit
Auto Test
Fixture Test
Manual Test
Fixture use time
Fixture
Lamp On Time
Information
Firmware Version
Pan & Tilt
Color
Reset Function
Shutter & Dimmer
Zoom
All
Fixture
Maintenance
Special
Functions
Factory Settings
Legend™ 1200E Wash User Manual
Selection Instruction
1~512 DMX starting address assignment
Operating mode: Basic
Mode 1 (16)
Mode 2 (21) Operating mode: Advanced
View the DMX input values (only from the starting address
-
through the last channel of the mode (23/31)
Yes/No Inverts the Pan operation from 540~0
Yes/No Inverts the Tilt operation from 270~0
Enables Blackout while pan/tilt moving
Yes/No
Yes/No Enables Blackout while Color moving
- Manual Control of the lamp state
On/Off Automatically strikes the lamp upon powering on the fixture
Yes/No Allows remote Lamp Off commands to be received via DMX
Yes/No Strikes the lamp if DMX is present
Yes/No Turns off the lamp if DMX is not present
Maintains the fans at highest speed, regardless of lamp
High
temperature
Maintains the lowest (most silent), possible fan speed, according
Auto
to the lamp temperature
0~255 Delays striking the lamp to allow for lower inrush currents
Sets the time activating delay between the shutter/dimmer
0~255 closing and the lamp power reduction. The maximum delay is
255 seconds
Yes/No Inverts the display graphics 180°
Turns off the backlight after several seconds of being idle
Sets the backlight intensity from dim to bright
°C Displays the temperature in Celsius
Displays the temperature in Fahrenheit
°F
- Runs the fixture, testing each function in series
Manually control each function of the fixture directly from the
- control panel without a DMX controller; for
testing/troubleshooting purposes
- Displays the amount of time the fixture has been operating
Exit Exits this function
Resets the lamp time (used when replacing the lamp in the
Reset Time
fixture)
- Displays the firmware version of each software chip
Yes/No Resets the pan & tilt, independent of the other motors
Resets the color wheel, CMY, & 3200 K (CTO) dichroic flags,
Yes/No
independent of the other motors
Yes/No Resets the shutter & dimmer, independent of the other motors
Yes/No Resets the zoom, independent of the other motors
Yes/No Resets all motors in the fixture simultaneously
Interval User can set the custom time for this Warning message
Leaving Time Shows the time remaining from the current interval user time
Resets all settings to the factory defaults, with the exception of
Yes/No
the motor offset settings
16 8/13/2009 10:55 AM