Miscellaneous Control - JETWAY PT800DB User Manual

Current CPU Temperature/Current System Temp/Current FAN1, FAN2 Speed/Vcore/ Vdd/
3.3V/+5V/+12V/-12V/VBAT(V)/5VSB(V)
This will show the CPU/FAN/System voltage chart and FAN Speed.
Detect CPUFAN in Post
During Enabled, system will warn the user if CPU Fan is not functioning.

Miscellaneous Control

3-11
This section is for setting CPU Frequency/Voltage Control.
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
CPU Clock Ratio
Auto Detect DIMM/PCI Clk
Spread Spectrum
** Current Host/PCI Clock is 100/33MHz **
Host/PCI Clock at Next Boot is
** Current DRAM Clock is 133MHz **
DRAM Clock at next Boot is
VCCQ Select
+2.5V Select
VDIMM Select
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Auto Detect DIMM/PCI Clk
This item allows you to enable/disable auto detect DIMM/PCI Clock.
Spread Spectrum
This item allows you to set the CPU Host/PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
Host Clock at next Boot is
This item allows you to select CPU frequency step by step increasing
The choice are: 100MHz∼132MHz, 133MHz∼165MHz, 166MHz∼255MHz.
DRAM Clock at next Boot is
This field displays the capability of the memory modules that you can use
The choice is either 100MHz or 133MHz or 166MHz or 200MHz.
VCCQ Select
This item allows you to select 1.5V of the AGP 4X/8X VGA card. The choice are: 1.5V, 1.6V.
VDIMM Select
This item allows you to select 2.5V of the DDR Module. The choice are: 2.5V, 2.6V, 2.7V, 2.8V.
Miscellaneous Control
8X
Enabled
Disabled
100/33MHz
133MHz
1.5V(Default)
2.5V(Default)
2.6V(Default)
F6:Optimized Defaults
39
Item Help
Menu Level >
F7:Standard Defaults