Onchip Super Io Function; Onboard Super Io Function - JETWAY PT800DB User Manual

3-7-3

Onboard Super IO Function

CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART2 Mode
RxD, TxD Active
IR Duplex Mode
Use IR Pins
Onboard Parallel Port
Parallel Mode
EPP Mode Select
ECP Mode Use DMA
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system board
and you wish to use it. If you install add-on FDC or the system has no floppy drive, select
Disabled in this field. The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and the second serial ports. The
settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART2 Mode
This item allows you to determine which InfraRed(IR) function of the onboard I/O chip, this
functions uses.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that Provides Standard, ECP,
and EPP features. It has the following option:
Disabled
(3BCH/IRQ7)/
(278H/IRQ5)/
(378H/IRQ7)
Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
Onboard Super IO Function
F6:Optimized Defaults
Line Printer port 0
Line Printer port 2
Line Printer port 1
Enabled
3F8/IRQ4
2F8/IRQ3
Normal
Hi, Lo
Half
IRRX/IRTX
378/IRQ7
SPP
EPP1.7
3
33
Item Help
Menu Level >>
F7:Standard Defaults