JETWAY PT800DB User Manual page 42

CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
PnP OS Installed
Reset Configuration Data
Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration Data
(ESCD) when you exit Setup if you have installed a new add-on and the system reconfiguration
has caused such a serious conflict that the operating system can not boot. The settings are:
Enabled and Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot and
Plug and Play compatible devices. However, this capability means absolutely nothing unless
you are using a Plug and Play operating system such as Windows  95/98. If you set this field
to "manual" choose specific resources by going into each of the sub menu that follows this field
(a sub menu is preceded by a ">").
The settings are: Auto(ESCD), Manual.
IRQ Resources
When resources are controlled manually, assign each system interrupt a type, depending on the
type of device using the interrupt.
Please refer to section 3-9-1
PCI/VGA Palette Snoop
Leave this field at Disabled. The settings are Enabled, Disabled.
PnP/PCI Configurations
No
Disabled
Manual
Press Enter
Disabled
Enabled
Enabled
F6:Optimized Defaults
37
Item Help
Menu Level >
F7:Standard Defaults