Mounting And Powering The Radio - Cobra Marine MR F75 EU Owner's Manual

Intro Operation Customer
Assistance
Mounting and
Powering the Radio
Installation and Start-Up Introduction
Customer
Installation Intro Operation
Assistance

Mounting and Powering the Radio

Secondary Icons
Before using your CobraMarine ™ VHF radio, it must be installed on your vessel.
Installing Your Radio
Installation
Choose a location for your radio where it will be conveniently accessible with the
Notice Caution
following factors in mind:
Secondary Icons
The leads to the battery and the antenna are best kept as short as possible.
The antenna must be mounted at least 1 metre from the transceiver.
The radio and all speakers need to be far enough from any magnetic
Notice
compass to avoid deviation due to the speaker magnet.
There needs to be free air flow around the heat-sink fins on the back
of the transceiver.
Surface Mount
A Surface Mounting kit is included with your CobraMarine
installation on almost any flat surface.
Surface Mounting Kit
s n o I c n a i M
e r m o s t u C n i o a t e r p O o t r I n
e c n a i s t s s A
Tilt Lock Knobs
e r m o s t u C
n i o a t a l l s t I n
e c n a i s t s s A
s n o I c y a r d n o c e S
n i o u t a C e i c o t N
26 English
Warranty
Customer Warranty
Assistance
Customer
Assistance
Warning
Caution Warning
™ VHF radio to allow its
To mount the transceiver on
almost any flat surface:
1. Use the mounting bracket as a template
to drill holes for the mounting screws.
2. Attach the mounting bracket to the
chosen surface.
3. Attach the transceiver to the mounting
bracket with the locking knobs.
4. Tilt the transceiver to a convenient
angle and tighten the locking knobs.
Intro Operation
Installation and Start-Up
Installation
Microphone/Speaker
•
Bracket
Secondary Icons
Main Icons
Notice
Intro Operation
Use Supplied Template
Installation
Secondary Icons See page 67
for template.
Insert Transceiver
Notice
Attach Mounting Brackets
Adjust Screws
Customer Warranty
Assistance
Mounting and
Powering the Radio
Customer
Assistance
Microphone/Speaker Bracket
To install the microphone/speaker bracket:
1. Install the microphone/speaker bracket
on a vertical surface near the transceiver
using the supplied stainless steel screws.
Caution Warning
Flush Mount
Customer Warranty
A Flush Mounting kit is included with your CobraMarine
Assistance
VHF radio to allow its installation in almost any flat surface.
To mount the transceiver flush in almost any flat surface:
Customer
1. Use the supplied template to mark and cut an opening
Assistance
in the flat surface. See page 67 for template.
CAUTION
Before cutting, be sure the area behind the flat
surface is clear of any instruments or wires that
Caution Warning
might be damaged in the process.
2. Insert the transceiver into the opening.
3. Attach the mounting brackets to
the sides of the transceiver with
the adjusting screw flanges facing
the back of the flat surface.
4. Tighten the adjusting screws against
the back of the flat surface until the
flange on the front of the transceiver
is tight against the flat surface.
Nothing comes close to a Cobra
™
® 27