Table of Contents
Advertisement
[Protocol] Page
This page sets the protocol.
This page can be used during access using
"admin".
Memo :
Press the [OK] button to enable the new
0
settings.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
When you connect via Internet Explorer after
0
changing protocol settings, enter the address
using the new server port and port number in the
address bar.
Settings
.
* Setting values with R are default values.
[Advanced Settings] Page - [Protocol] Page
46
Protocol Settings
Sets the protocols.
9 HTTP Server Port
You can change the port number for the built-in
HTTP server of the camera.
[Set values: 1 to R80 to 65535]
Memo :
To access the camera from Internet Explorer,
0
input the following into the Internet Explorer
address bar with the camera in the factory
default state.
http://192.168.0.2
When the port number is changed to 8080, input
the new port number after the IP address as
follows.
http://192.168.0.2:8080
Input ":" + port number
Upon changing the HTTP server port, the port
0
number for requesting video stream distribution
will also be changed.
Set [HTTP Port] of the Built-in Viewer to the
0
same value.
(A P61 [ HTTP Port ] )
9 AMX Device Discovery Protocol
You can change the AMX device detection
protocol. Set to "ON" when you are using the
camera on AMX's system.
[Set values: RON, OFF]
Advertisement
Table of Contents
