JVC VN-H657U Instructions Manual page 20

5 Connect the power cable.
To supply power from an AC 24 V power
0
supply, connect a power cable.
To supply power via PoE plus, you do not
0
need to connect a power cable. Go to the
next step.
(A P20 [Connect the LAN cable.] )
Power cord for connecting to AC 24 V
.
(Reference value)
Conductor Diameter
(mm)
φ1.0 and above
φ1.6 and above
φ2.0 and above
φ2.6 and above
Memo :
By default, the IP address of the camera is set
0
to 192.168.0.2.
Note :
For safety reasons, turn on the power only after
0
ensuring that all the connections are in place.
If power is supplied from both power cable and
0
LAN cable, priority will be given to the power
supply from the power cable.
If multiple cameras are turned on
0
simultaneously in the same LAN environment,
access attempts may fail due to IP address
duplication. Set up an IP address by either using
the JVC-VN-IP SettingTool (included on the
supplied CD-ROM) or turning the power supply
of each camera on separately to avoid
duplication.
Installation and Connection Preparations
20
Power cable
To the AC 24 V
terminal
Maximum connection
distance (m)
40
130
200
350
Caution
To supply power to this product, make use of AC
24 V 50 Hz/60 Hz or PoE Plus (IEEE802.3at
Type2). Make sure to use it with the correct
voltage.
Be sure to use an AC 24 V supply that is isolated
from the primary power supply circuit.
Supplying a power beyond the rated value may
result in failures, smoke or fire. If the camera
breaks down, turn off the power and contact your
dealer immediately.
When a power beyond the rated value is
supplied, the internal components may be
damaged even if no abnormality is found on the
appearance and operation of the camera.
Please contact your dealer immediately for
servicing (charged separately).
6 Connect the LAN cable.
Connect the camera to a hub or computer
.
0
using a LAN cable.
When connecting to a hub: Make use of a
0
straight cable.
When connecting to a computer: Make use
0
of a cross cable.
LAN cable to use
STP (Recommended shield cable)
0
Length of 100 m or shorter
0
Category 5e and above
0
LAN cable
[10BASE-T/
100BASE-TX]
LAN cable
connection
terminal