Technical Specifications - Tannoy V8 User Manual

11. Technical Specifications

Frequency response (1) +/ - 3dB
-10dB Point
Recommended Amplifier Power
Power Handling
Sensitivity (1)
2.83 volt @ 1m
Maximum SPL (3)
@ 1m
Impedance
DI Averaged (PCQ)
@ 1kHz (ISO)
@ 2kHz (ISO)
@ 4kHz (ISO)
@ 8kHz (ISO)
@ 16kHz (ISO)
Q Averaged (PCQ)
@ 1kHz (ISO)
@ 2kHz (ISO)
@ 4kHz (ISO)
@ 8kHz (ISO)
@ 16kHz (ISO)
Distortion
0.1 Full Power
250 Hz
1000 Hz
10000 Hz
0.01 Full Power
250 Hz
1000 Hz
10000 Hz
Driver Complement
Crossover Point
Enclosure
Finish
Protective Grille
Connectors
Fittings
Dimensions
Weight
NOTES:
All Tannoy V Series products can be used with the Tannoy TDX2 Digital Controller for optimum system performance and when
being used with various sub bass systems. Please visit our website at
Tannoy operates a policy of continuous research and development. The introduction of new materials or manufacturing methods will
always equal or exceed the published specifications, which Tannoy reserves the right to alter without prior notice.
Please verify the latest specifications when dealing with critical applications.
(1) Average over stated bandwidth. Measured at 1m on axis.
(2) Long term power handling capacity as defined in EIA standard RS - 426A.
(3) Unweighted pink noise input, measured at 1m in an anechoic chamber.
85Hz – 22kHz
65Hz – 22kHz (with Tx1/TDX2 controller)
51Hz (48Hz with Tx1/TDX2)
100 - 260 watt / 8 ohm
Average (2) Programme Peak (10ms)
130 watt 260 watt 520 watt
92 dB (anechoic) 95 dB (half space)
Average Peak
113 dB 119 dB
Nominal 8.0 ohm
9.11, 250 Hz - 16 kHz
7.8
8.3
9.5
11.2
13.4
9.93, 250 Hz - 16 kHz
6
6.8
8.9
13.2
21.9
2nd Harmonic 3rd Harmonic
0.141% 0.126%
0.251% 0.794%
1.340% 0.251%
2nd Harmonic 3rd Harmonic
0.100% 0.112%
0.100% 0.56%
0.56% 0.178%
1 x 8" (200mm) Constant Directivity Dual Concentric
Type number 2062
Passive 1.7 kHz
th nd
4 order high pass, 2 order low pass
Dynamic HF protection
17 litre vented, Birch plywood
Textured black paint (optional in white)
Foam covered powder coated perforated steel.
2 x NL4MP, IN/OUT
Recessed rear mounted carrying handle,
Blanking plate allows installation of a 35mm pole-mounting socket,
2 x M10 inserts for yoke mount, 4 x M10 flying inserts, 4 x M10 brack
(to suit Tannoy or Omnimount 50
388mm(H) x 280mm(W) x 275mm(D)
15.28"(H) x 11.02"(W) x 10.83"(D)
8.2 Kg (18 lbs)
www.tannoy.com for further details
bracket)