Ipx7; Safety Precautions; Regulatory Information - Mio Cyclo 100 Series User Manual

IPX7

The IEC 60529/IPX7 is a European system of test specification standards for
classifying the degrees of protection provided by the enclosures of electrical
equipment. An IPX7 designation means that the unit withstands immersion in
one meter (approx 3ft) of still water for up to 30 minutes. Mio guarantees this
grade provided the battery door and all jack covers are properly and securely
closed. Mio Cyclo is not IPX8 grade; water-pressure such as washing the unit
with running water may cause damage to the unit and voids warranty.

Safety precautions

• About charging
• Use only the charger supplied with your device. Use of another type of
charger will result in malfunction and/or danger.
• This product is intended to be supplied by a LISTED Power Unit marked
with "LPS", "Limited Power Source" and output rated + 5 V dc / 1.0 A".
• Use a specified battery in the equipment.
• About the charger
• Do not use the charger in a high moisture environment. Never touch the
charger when your hands or feet are wet.
• Allow adequate ventilation around the charger when using it to operate
the device or charge the battery. Do not cover the charger with paper or
other objects that will reduce cooling. Do not use the charger while it is
inside a carrying case.
• Connect the charger to a proper power source. The voltage requirements
are found on the product case and/or packaging.
• Do not use the charger if the cord becomes damaged.
• Do not attempt to service the unit. There are no serviceable parts inside.
Replace the unit if it is damaged or exposed to excess moisture.
• About the battery
• Use a specified battery in the equipment.
CAUTION: This unit contains a non-replaceable internal Lithium Ion
battery. The battery can burst or explode, releasing hazardous chemicals.
To reduce the risk of fire or burns, do not disassemble, crush, puncture, or
dispose of in fire or water.
• Important instructions (for service personnel only)
• Caution: Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
• Replace only with the same or equivalent type recommended by the
manufacturer.
• The battery must be recycled or disposed of properly.
• Use the battery only in the specified equipment.

Regulatory information

For regulatory identification purposes, Mio Cyclo 100/105 series is assigned a
model number of N411.
Marking labels located on the exterior of your device indicate the regulations
that your model complies with. Please check the marking labels on your device
and refer to the corresponding statements in this section. Some notices apply
to specific models only.
Products with the CE marking comply with Radio & Telecommunication
Terminal Equipment Directive (R&TTE) (1999/5/EC), the Electromagnetic
Compatibility Directive (2004/108/EC) and the Low Voltage Directive
(2006/95/EC) - issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European
Standards:
EN 301 489-1: Electronic compatibility and Radio spectrum Matters (ERM),
Electromagnetic Compatibility (EMC) standard for radio equipment and
services; Part 1: Common technical requirements.
EN 301 489-17: Electronic compatibility and Radio spectrum Matters (ERM),
Electromagnetic Compatibility (EMC) standard for radio equipment and
services; Part 17: Specific conditions for 2.4 GHz wideband transmission
systems and 5 GHz high performance RLAN equipment.
EN 55022: Radio disturbance characteristics
EN 55024: Immunity characteristics
EN 61000-3-2: Limits for harmonic current emissions
20