Factory Reset; Gps Setting; Map Mode; Memory Status - Mio Cyclo 100 Series User Manual

FACTORY RESET

This function allows you to restore the device back
to factory default status.
Warning! The training data and user profile will be
erased.

GPS SETTING

• WAAS/EGNOS*: You can disable or enable the
WAAS/EGNOS function of the device.
* WAAS (Wide Area Augmentation System) and EGNOS
(Euro Geostationary Navigating Overlay Service)
are used to improve the GPS accuracy, integrity and
availability.
• GPS: The GPS function can be turned off for
saving battery power. If the battery power is low,
the system will also ask you if you want to turn
off the GPS function.
• GPS INFO: This item displays the positioning
status of how many satellite signals are obtained
and the signal strength.

MAP MODE

You can change the viewing angle by selecting
NORTH UP or BIRD'S EYE VIEW:
• NORTH UP: Always display North at the top of
• BIRD'S EYE VIEW: Displays the aerial image of

MEMORY STATUS

This item displays the memory status of the device,
allowing you to check how many points left and the
remaining time. The remaining time depends on the
period of your record setting.

PAGE SETTINGS

There are 4 Custom pages, one Time screen, one
Map screen, one Compass screen, and one Lap
screen included in the DASHBOARD screens to
display your training/workout status.
• CUSTOM 1/2/3/4: The number displayed on
15
the Map screen.
the location viewed at an angle of approximately
45 degrees.
the screen indicates the data fields (e.g. speed,
distance, time, calories, etc.) included in the
target screen.