Slope; Sys Upgrade; System - Mio Cyclo 100 Series User Manual

SLOPE

Select the time interval (20/45/90 SECONDS)to
collect the data for analysing the slope.

SYS UPGRADE

This item allows you to upgrade the firmware of
your device.

SYSTEM

• BEEPER: You can enable the beeper that
accompanies MESSAGE ONLY or both of KEY
AND MESSAGE.
Otherwise, select OFF to disable the beeper.
• TOD MODE: The system will enter TOD mode
(time-of-day) if in standby for a specific time.
The available settings for standby include: OFF, 5
MINUTES, or 10 MINUTES.
In TOD mode, press UP for 2 seconds to return to
normal operation mode.
• DISPLAY:
- BACKLIGHT: Set the backlight to stay on or
automatically turn off after a period of time
once you press LIGHT to activate the backlight.
• TIME:
• ALARM: In the FREQUENCY field, you can set
17
The available setting includes: STAYS ON, 15
SECONDS, 30 SECONDS, 1 MINUTE, or 2
MINUTES.
You can also adjust the screen contrast level by
sliding the Contrast bar.
- LANGUAGE: You can select the preferred
language displayed for the menus and other
interface features while operating the device.
- ORIENTATION: For certain applications, you
can set the screen orientation as PORTRAIT or
LANDSCAPE.
Tip: Pressing ENTER and LAP simultaneously allows
you to rotate the screen quickly.
- UNITS: The measurement unit can be set as
IMPERIAL(FT,MPH) or METRIC(m,kph).
You can also set the COORDINATE FORMAT as
DEGREE or DEG MIN SEC.
- TIME FORMAT: Set the displayed time format
as 12 HOUR or 24 HOUR.
- TIME ZONE: Select your local time zone.
- DAYLIGHT SAVING: Select the daylight saving
if necessary, and then the system will display
the correct time according to your setting.
the alarm clock from Sunday to Saturday (SUN/
MON/TUE/WED/THU/FRI/SAT), WEEKDAY,
WEEKEND, or DAILY. Otherwise, select OFF to
disable the alarm.
Once the alarm is enabled, set the alarm time in
the TIME field.