Belkin F6D4230-4 User Manual page 95

INfoRMaTIoN
sections
table of contents
fCC statement
dEClaRaTIoN of CoNfoRMITy WITH fCC RUlEs foR ElECTRoMagNETIC CoMPaTIbIlITy
We, Belkin International, Inc�, of 501 West Walnut Street, Compton, CA
90220, declare under our sole responsibility that the device,
f6d4230-4
complies with Part 15 of the FCC Rules� Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation�
Caution: Exposure to Radio frequency Radiation
The device shall be used in such a manner that the potential for human
contact during normal operation is minimized�
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment� This equipment should be installed and operated
with a minimum distance of 20cm between the radiator and your body�
For information on product disposal please refer to
http://environmental�belkin�com
FoR Use in At Be cY cZ DK
it LV Lt LU Mt nL PL Pt
no cH BG Ro tR
Restricted Use in certain countries
150N Wireless Router
1 2
0560
ee Fi FR De GR HU ie
sK si es se GB is Li
oPeRAtes on cHAnneLs 1-13
class 2 equipment
3 4 5
federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules� These limits
are designed to provide reasonable protection against harmful interference
in a residential installation�
This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications� However, there is no
guarantee that interference will not occur in a particular installation� If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user
is encouraged to try and correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna�
• Increase the distance between the equipment and the receiver�
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected�
•
Consult the dealer or an experienced radio/TV technician for help�
For IEEE 802�11b/g products in the USA market, only channels 1 through 11
can be operated� Selection of other channels is not possible�
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter�
93
6 7 8 9 10