Table of Contents
Advertisement
O
PERATION
R
frequency (receive frequency vs transmission frequency) will appear on the display.
Press the [ ] / [ ] (move the digit) and [ ] / [ ] (select the number) button to im-
prove the sound of the incoming signal. These
buttons functions does not affect your transmis-
sion frequency; only the receive frequency is
being adjusted (up to ±1.000 kHz). Press and hold in both [ ] and [ ] buttons for
one second to reset the offset.
Important Note: The transceiver can not transmit while adjusting the clarifier offset.
If you wish to transmit, press the [ CLAR ] button again to return to normal display.
Press the [ CLAR ] button again to return to normal display. When the receiving fre-
quency is higher than displayed frequency, the
" " icon will appear in the upper side of the
frequency display. Similarly, when the receiv-
ing frequency is lower than displayed frequency, the "
" icon will appear in the
upper side of the frequency display.
Important Note: Keep offset frequency until you change the operating frequency or
reset the offset by pressing and holding both [ ] and [ ] buttons for one second.
If the LCD display is too bright, press the [ DIM ] button (the [ P
] button
ROGRAMMABLE
which assigns the "Dimmer" function: the factory default is [ S1 ] button) to reduce
the display brightness. Press the [ DIM ] button again return to the LCD display to
nominal brightness level.
Press the Programmable Function ([ P0 ] ~ [ P4 ], [ S1 ] & [ S2 ]) buttons to activate the
function which is corresponding with that button. Refer to page 42 for the details of
the Programmable Function button.
VX-1400 O
M
21
Advertisement
Table of Contents
