Displays; Function Keys - Diamondback 400Tm Owner's Manual

Displays:

• Clock Set Up:
The Data display acts as a clock during idle mode. Please run below
procedures for initial or after power off to set up the clock function. Without
going thru clock setting procedure, the display will stay showing "12:00" and
clock function will not be activated.
o The initial Data display shows the default display of "12:00" when you
first turn on the power.
o Press data display "SELECT" button once during idle mode will enter
clock setting mode. And "12" will be blinking, press UP/DOWN key to
adjust the hour setting from 0-12. Press "DOWN" key to adjust from
12:00 down if the current time is AM; and press "UP" key to adjust
from 12:00 up if the current time is PM.Press "ENTER" to confirm.
o After ENTER pressed, "00" will be blinking and wait for an entry. Press
UP/DOWN key to adjust the minute setting.
o Press ENTER to confirm the minute setting and start the clock function.
A. Workout data display
a. Speed and Incline display
• Speed (mph) — Current speed.
• Incline (%) — current incline %
b. Data display
As soon as a program is started, it will start displaying the default workout data:
time. You may select your favorite data displays by pressing the "SELECT" button,
the LED indicator will light up to show which data is displaying.
• Time (hr: min or min: sec): The remaining of program time.
• Distance (mile or km): Total workout distance.
• Calories (kcal): Total workout calories.
• Heart rate (bpm): Your current heart rate. If there is no pulse detected, it
will display " - - - " instead.
• Scan: if Scan function is selected, the display will show above data for
5 seconds each.

Function keys:

a. Speed UP/DOWN keys:
o During program setup, press Speed "UP/DOWN" key to adjust the
following — age, weight & time setting.
o After program started, press Speed "UP/DOWN" key to adjust the
speed.
o Speed increment = 0.1mph.
b. Incline Up/Down keys:
o During program setup, press incline "UP/DOWN" key to adjust the
following — age, weight & time setting.
o After program started, press Incline "UP/DOWN" key to adjust the
incline.
o Incline increment = 0.5%.
400 Tm Owner's Manual
Console Layout (continued)
Speed & Incline
Display
Data Display
Function Keys
17