Finalizing The Installation - Lopi heritage Owner's Manual

Installation

Finalizing the Installation

! Turn the gas control valve to "OFF" prior to conducting any service.
1 Open the door (see page 17).
2 Install the log set and coals (see page 18).
! We recommend you purge the gas line at this time (with the door open). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3 Close and secure the door (see page 17).
4 Turn on gas to the heater. Leak test all gas joints prior to starting the appliance. Start the pilot. Start
the main burner. Leak test all gas joints again.
5 Check the pilot flame to make sure it looks like the illustration below. Adjust the pilot flame if
necessary.
To adjust the pilot flame, turn this screw (NOTE: if totally
unscrewed gas will come out of this port). Clockwise
lowers the flame while counter-clockwise raises it.
6 Let the heater burn
for fifteen minutes.
Adjust the air
shutters, if
necessary, to
achieve the correct
looking flame (see
the illustration
below).
• The air shutter
adjusts the amount
of air that mixes with
the gas before it
exits the burner
holes.
Travis Industries
(for qualified installers only)
Standard
Screwdriver
Open the access panel - the air shutters are above the gas control
a
valve.
Follow the directions below to adjust the front and rear air shutter
b
independently.
Rear Air Shutter
Left = Less Air (closed)
Right = More Air (open)
NOTE: If the air control is all the way open, yet the flames
remain sooty, shut off gas to the fireplace and contact a
qualified gas service technician.
NOTE: The logs must be installed correctly to monitor the
flame while adjusting the air shutter.
Correct
Flames should be blue at the
base, yellow-orange on the top.
100-01135
The pilot flame must contact the thermocouple and
thermopile (see the illustration below). Adjust the pilot up or
down as necessary.
Front Air Shutter
Left = Less Air (closed)
Right = More Air (open)
Not Enough Air
If the flames are over 12" tall or sooty
on the ends, push the air control in.
15
Too Much Air
If the flames are all blue and
short, pull the air control out.
4 0 4 0 8 0 9