Great Dane Super Surfer Series II GSKH2352S Operator's Manual page 37

If
Engine Lacks Power
Engine Uses Too Much Oil
Engine Backfires Through
Muffler
High Fuel Consumption
Other Symptoms
Electrical System
If
Starter Will Not Work
Battery Will Not Charge
PTO Switch Does Not Work
TROUBLESHOOTING
Check
• Reduce load.
• Plugged air intake system.
• Plugged fuel filter.
• Improper type of fuel. Drain tank and
fill with correct fuel.
• Clean cooling fins to help prevent
overheating.
• Replace spark plugs.
• Find and correct oil leaks.
• Incorrect engine oil.
• Plugged oil filter.
• Plugged air intake filter.
• Worn engine components.
• Throttle lever should be at low idle for
thirty seconds before turning off
machine.
• Improper type of fuel.
• Plugged air intake system.
• Operating at too fast ground speed for
conditions.
• Improper valve clearance. See your
authorized dealer.
• Restricted air intake system.
• See engine manufacturer's owner's
manual provided with your machine for
additional information.
Check
• Blown fuse.
• Park brake switch is faulty.
• Loose or corroded battery
connections.
• Neutral switches faulty or not adjusted
properly. See your authorized dealer.
• Key switch or starter faulty. See your •
authorized dealer.
• PTO engaged.
• Motion control levers and park brake
lever not in proper position.
• Loose or corroded connections.
• Blown fuse or fusible link. See your
authorized dealer.
• Blown fuse.
• PTO switch faulty.
If
Starter Turns Slowly
Machine
If
Excessive Machine Vibration
Machine Will Not Move With
Engine Running
Machine Creeps With Engine
Running and Motion Control
Levers in a Neutral Position
Park Brake
If
Park Brake Not Working
Correctly
Steering
If
Steering Not Working
Troubleshooting - 35
Check
• Loose or corroded battery
connections.
• Low battery power-charge battery.
• Engine oil viscosity too heavy.
• Hydraulic pump linkage out of
adjustment-pumps engaged.
Check
• Engine speed too slow.
• Deck drive belt not tensioned
correctly.
• Mower blades not balanced.
• Park brake locked.
• Transmission oil level low.
• Transmission oil cold – allow engine to
warm up.
• Pump drive belt slipping or broken.
• Pump drive belt spring broken.
• Pump free-wheel valves open.
• Transmission problems. See your
authorized dealer.
• Needs motion control linkage
adjustment.
• Needs ? Adjustment.
Check
• Park brake out of adjustment – adjust
linkage.
Check
• Pump free-wheel valves partially
open.
• Improper tire inflation.
• Hydrostatic transmission oil level low.
• Traction drive loose or broken.
• Hydraulic pump or wheel motor faulty.