Burnishing The Pto Clutch - Great Dane Chariot / Chariot LX GDRZ48-17KAE Operator's Manual

SERVICE ELECTRICAL
B
C
A
MX15337
Chariot LX models equipped with Kohler EFI engines have
three additional fuses:
• One 10-amp fuse (A), used to protect the fuel pump
circuit.
• One 20-amp fuse (B), used to protect the main power
circuit.
• One 30-amp fuse (C), used to protect the charge circuit.
1. Remove defective fuse from socket.
2. Check metal clip in fuse window and discard fuse if clip
is broken.
3. Install new fuse into socket.

Burnishing the PTO Clutch

NOTE: The clutch will only require burnishing if a new
clutch has been installed.
1. Start and run the engine at 1/2 throttle.
2. Engage and disengage the PTO clutch five times (ten
seconds on, ten seconds off).
3. Move throttle lever to 3/4 throttle.
4. Engage and disengage the PTO clutch five times (ten
seconds on, ten seconds off).
Service Electrical - 53