Fingerprint Reader Board - HP EliteBook 2560p Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board
Before removing the fingerprint reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Service access cover (see
b. Keyboard (see
c. Base enclosure (see
d. Top cover (see
Remove the fingerprint board:
1. Remove the Phillips M2.0x3.0 screw (1) from fingerprint reader frame, and then remove the
frame (2).
2. Remove the tape (3) from fingerprint reader cable, and then remove the board and cable (4)
from the top cover.
Reverse this procedure to install the fingerprint reader board.
Battery on page 41), and then remove the following components:
Service access cover on page
Keyboard on page 62.)
Base enclosure on page
Top cover on page 71.)
42.)
66.)
Component replacement procedures
Spare part number
651364-001
75