Table of Contents
Advertisement
Optional Equipment
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1
Remove the face and glass (see page 22). Remove the log set (if installed - page 23)
2
Remove the burner (see illustration below).
Reach into the firebox and
lift the burner upwards.
Do not lift burner out by the
pins.
Pull the burner forward, out
of the firebox.
Older Model Burners
Older models (Berkshires s.n. 857740
or less - Prairies s.n. 801307 or less)
utilize a different burner and mounting
method (see illustration to right). If
replacing the burner, refer to the
instructions included with the
replacement burner for installation
instructions.
Travis Industries
When Installing, make sure the burner rests
on this ledge with the center air channel fitting
over this tab.
When Installing, make sure the burner rests
on the two ledges at the sides of the firebox.
1 0 0 - 0 1 1 5 9
(for qualified installers only)
This tube on the burner
inserts into this tube on the
mixing tube.
3 5
4 0 4 0 6 2 1
Hide quick links:
Advertisement
Table of Contents
