Adjusting The Blower Speed (Optional); Normal Operating Sounds; Normal Operating Odors - Lopi Berkshire Owner's Manual

Adjusting the Blower Speed (optional)

The blower helps transfer the heat from the heater into the room. It will not turn on until the heater is
up to temperature (approximately 10 minutes after starting). See the illustration below for instructions
on adjusting the blower speed.
OFF
Turn the dial all
the way counter-
clockwise until it
clicks off.
ON
OFF

Normal Operating Sounds

Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Gas Control Valve
As the gas control valve is turned
on and off you will hear a dull
clicking sound. This is the valve

Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these areas may
burn and create a burnt-paper smell. This is normal during startup. You may notice the smell is more acute
if the appliance was left idle for a long period.
Travis Industries
Operation
HIGH
The high position is
all the way counter-
clockwise, without
clicking off.
ON
OFF
The appliance may creak with change of
temperature -- THIS IS NORMAL.
1 0 0 - 0 1 1 5 9
LOW
Turn the dial
all the way
clockwise.
ON
OFF
Blower
This heater uses a blower to push heated
air into the room. You will hear the sound
of air movement that increases as the
speed is increased.
Extinction Pops
It is not unusual, especially on Propane
(LP) appliances, to experience a "pop"
when the burner is shut off.
Blower Snap Disk
This part can produce a clicking sound as
2 7
4 0 4 0 6 2 1