Control Board - Splendide AW 122 Training Manual

12. CONTROL BOARD

• To remove the Control Board, remove the two (2) T-15 Torx screws located at the rear right corner of the
A
A
Fig. 12-1
TECH NOTE
On/Off Switch / Door Switch
REPAIR MANUAL
unit. Also remove the plastic cap (A) by prying it off with a small screwdriver (Fig. 12-1). Disconnect the
wire harness connections and remove the Control Board through the rear access opening.
TECH NOTE: Replacement Control Boards DO NOT come with the EEPROM Chip installed. You must
order the EEPROM Chip which corresponds to the Model Number being serviced
separately. Remember to always order the Control Board AND EEPROM Chip. Use care
when installing the EEPROM Chip making sure not to bend any of the contact prongs.
Surge Protector
NTC's / LED's
Program Selector Module
Selector Switches / Potentiometers
Water Valves
Blower Motor / Drain Motor
Main Motor
Heater
Pressure Switch
AW 120 / AW 122 / AW 125
AWD 120 / AWD 121 / AWD 129
Page: 11