Installation Information; Installation Requirements - Splendide WD2100XC Training Manual

I n s t a l l a t i o n I n f o r m a t i o n
Check these location, plumbing and electrical installation requirements for a proper washer-dryer installation.
Electrical
• Machine Voltage/Amperage - 120V, 60 Hz, 1300
W, 10.5 Amp.
• Connection - 3-prong plug with 6' cord is
provided with the machine.
• Circuit/Protector - 3-wire single phase, 120V, 60
Hz, AC, on a separate 15 Amp circuit.
Location
• This machine may be installed free standing as
well as in a recessed area, closet, or alcove
• Minimum Installation Spacing - 0" on sides
and 1" in front and back. NOTE: Additional
installation spacing needs to be considered for
easy installation, servicing, and compliance with
state and federal codes.
• Floor - Must support at least 280 lbs. and be a
solid, level surface. DO NOT install on carpet.
• RV/Marine Installations - When locating the
appliance in a towable trailer or watercraft,
position the machine over the axles or mid-ship
where movement is at a minimum. Block the
machine to prevent extreme movement.
• Exhaust Requirements (WD2100XC Model
ONLY) - Rigid or fl exible metallic duct required.
Ducting should be as short and straight as
possible. DO NOT exhaust dryer into a chimney,
furnace, cold air duct, attic crawl space, or
another duct used for venting. If a cabinet door
is installed, a minimum of 8 sq. in. should be
provided for make up air. Louvered doors with
equivalent air openings are acceptable. Allow
clearances behind door(s) to avoid rubbing
between back of cabinet door(s) and front of unit
control panel. Additional clearances for wall, door
and fl oor moldings may be required.

Installation Requirements

If you have...
no access to Hot/
Cold water hookups
to install a dryer
vent and ducting in
your RV or boat
concerns about the
appliance shifting in
your RV or boat
water damage
concerns
to make a 90" duct
turn in less than 4.5"
Drainage
•
•
•
You'll need...
Splendide Faucet Adapter Kit, or
equivalent.
Splendide Vent Kit, or equivalent.
Splendide SecureFit bracket kit, or
equivalent.
Splendide Drain-A-Way Pan, or equivalent.
Splendide 90˚ offset elbow, or equivalent.
Standpipe Diameter/Capacity - Needs a 1 ¼"
minimum diameter standpipe with a minimum
carry-away capacity of 7 gallons per minute.
Top of Standpipe - Must be between 25" and
34" high from the bottom of the machine.
Outlet End of Drain Hose (provided with the
unit) - Must be at least 20" above the bottom of
the washer-dryer. An air break must be available
at the standpipe to avoid siphoning. No more than
6" of the drain hose should be inserted into the
drain pipe to prevent siphoning.

Installation Information

5