Navigating With A Garmin Autopilot - Garmin GPSMAP 6008 Owner's Manual

Clearing the Active Track
From the Home screen, select
The track memory is cleared, and the current track continues to be recorded.
Managing the Track Log Memory During Recording
1. From the Home screen, select
Mode.
2. Complete an action:
Fill
• Select to record a track log until the track memory is full.
Wrap
• Select to continuously record a track log, replacing the oldest track data with new data.
Configuring the Recording Interval of the Track Log
You can indicate the frequency at which the track plot is recorded. Recording more-frequent plots is more
accurate but fills the track log faster.
1. From the Home screen, select
Interval.
2. Complete an action:
• Select Distance to record the track based on a distance between points. Select
distance. For the GPSMAP 6000 series, use the Rocker or the Numeric Keypad. For the GPSMAP
7000 series, use the on-screen keyboard. Select Done.
time
• Select to record the track based on a time interval. Select
GPSMAP 6000 series, use the Rocker or the Numeric Keypad. For the GPSMAP 7000 series, use the
on-screen keyboard. Select Done.
• Select Resolution
recommended for the most-efficient use of memory. Select
from the true course before recording a track point. For the GPSMAP 6000 series, use the Rocker or
the Numeric Keypad. For the GPSMAP 7000 series, use the on-screen keyboard. Select Done.
3. Select Done.
Copying Tracks
See "Chartplotter Data Management"
Deleting All Saved Waypoints, Routes, and Tracks
From the Home screen, select

Navigating with a Garmin Autopilot

When you start any type of navigation (Go To, Route To, Guide To, or Follow Track), if you are connected to a
compatible Garmin autopilot (such as the GHP
GPSMAP 6000/7000 Series Owner's Manual
®
Information > User Data
Information User Data
>
Information > User Data
to record the track plot based on a variance from your course. This setting is
(page 69).
Information > User Data
10), you are prompted to engage the autopilot.
™
> tracks > Clear Active
tracks Active track options
> >
> tracks > Active track options
Change
to set the time. For the
Change to enter the maximum error allowed
> Clear User Data > All.
Navigation
track.
Record
>
> Interval >
Change to set the
41