Bose PackLite Owner's Manual page 8

Svenska Nederlands
P L TM P
ACK ITE OWER
Figure 4
Typical setup
OUTPUT
A1 amplifier
B1 bass
modules
CAUTION:
A1 amplifier.
CAUTION:
module that is already connected to the Amp 3 OUT connector of
a PS1 power stand, or to another A1 amplifier.
Note:
recommended. Using balanced cabling prevents common
interconnect noise problems.
Note:
stacked in a column. Stacking may improve acoustic output.
Using multiple A1 amplifiers together
To add more bass capability to your system, you can connect
multiple A1 amplifiers as shown in Figure 5 on page 9.
1.
2.
3.
8
Italiano Français
A M A1
MPLIFIER ODEL
INPUT
PS1 power stand
Do not connect more than two B1 bass modules to an
Be careful not to connect the A1 amplifier to a B1 bass
Using the supplied ¼" TRS cable with your A1 amplifier is
Up to four (maximum) B1 bass modules can be
Connect the AC power cord to an AC (mains) outlet.
Make sure the Power switch is OFF.
Using the supplied ¼" TRS cable, connect the Bass-Line
OUT connector on the PS1 power stand to the INPUT
connector on the first A1 amplifier.
Español Deutsch
Bass-Line
OUT
Dansk English
B1 bass
modules