Supero SUPERSERVER 5017P-TLN4F User Manual page 43

Watch Dog Enable/Disable
Jumper JWD controls the Watch Dog
function. Watch Dog is a system moni-
tor that can reboot the system when a
software application hangs. Jumping
pins 1-2 will cause WD to reset the sys-
tem if an application hangs. Jumping
pins 2-3 will generate a non-maskable
interrupt signal for the application that
hangs. See the table on the right for
jumper settings. Watch Dog must also
be enabled in BIOS.
BMC Enable/Disable
JPB1 is used to enable or disable the
BMC (Baseboard Management Con-
trol) chip and the onboard IPMI con-
nection. This jumper is used together
with the IPMI settings in the BIOS.
See the table on the right for jumper
settings.
USB Wake-Up (JPUSB1)
Use the JPUSB1 jumper to enable system
"wake-up" via a USB device. This jumper
allows you to "wake-up" the system by
pressing a key on the USB keyboard or by
clicking the USB mouse of your system.
The JPUSB1 jumper is used together with
the USB Wake-Up function in the BIOS.
Enable both the jumper and the BIOS set-
ting to activate this function. See the table
on the right for jumper settings and jumper
connections.
Note: The default jumper setting is "Dis-
abled". When the "USB Wake-Up" function
is enabled, it will be active on all USB ports.
Chapter 5: Advanced Motherboard Setup
Setting
Pins 1-2
Pins 2-3
Open
Setting
Pins 1-2
Pins 2-3
Jumper Setting
Pins 1-2
Pins 2-3
5-15
Watch Dog
Jumper Settings
Definition
Reset
NMI
Disabled
BMC Enable
Jumper Settings
Definition
BMC Enabled
Disabled
USB Wake-Up
Jumper Settings
Definition
Enabled
Disabled (Default)