Table of Contents
Advertisement
S
S
UPER
ERVER 5017P-TLN4F/TF User's Manual
Power LED/Speaker
On the JD1 header, pins 1-3 are for
a power LED and pins 4-7 are for the
speaker. Close pins 4-7 with a jumper
to use an external speaker. If you wish
to use the onboard speaker, please
close pins 6-7. See the table on the
right for speaker pin definitions.
T-SGPIO Headers
The SGPIO (Serial General Purpose
Input/Output) headers are used to
communicate with the enclosure
management chip on the backplane.
See the table on the right for pin
definitions.
Overheat/Fan Fail LED
The JOH1 header is used to connect
an LED indicator to provide warnings
of chassis overheating and fan failure.
This LED will blink when a fan failure
occurs. Refer to the table on the right
for pin definitions.
PWR LED Connector
Pin Definitions
Pin Setting
Pin 1
Pin2
Pin3
Speaker Connector
Pin Setting
Pins 4-7
Pins 6-7
T-SGPIO Headers
Pin Definitions
Pin#
Definition
1
NC
3
Ground
5
Load
7
Clock
Pin Definitions
Pin#
1
2
OH/Fan Fail LED
State
Solid
Blinking
5-12
Definition
Anode (+)
Cathode (-)
NA
Pin Settings
Definition
External Speaker
Internal Speaker
Pin
Definition
2
NC
4
DATA Out
6
Ground
8
NC
Overheat LED
Definition
5VDC
OH Active
Status
Message
Overheat
Fan Fail
Advertisement
Table of Contents
