Exercising The System Using Sunvts Software - Fujitsu SPARC Enterprise T1000 Service Manual

If SunVTS software is not installed, you see an error message for each missing
■
package.
ERROR: information for "SUNWvts" was not found
ERROR: information for "SUNWvtsr" was not found
...
The following table lists the SunVTS packages:
Package
SUNWvts
SUNWvtsr
SUNWvtsts
SUNWvtsmn
If SunVTS is not installed, you can obtain the installation packages from the Solaris
Operating System DVDs.
The SunVTS 6.1 software, and future compatible versions, are supported on the
server.
SunVTS installation instructions are described in the SunVTS User's Guide.
3.8.2

Exercising the System Using SunVTS Software

Before you begin, the Solaris OS must be running. You also need to ensure that
SunVTS validation test software is installed on your system. See
"Checking Whether SunVTS Software Is Installed" on page
The SunVTS installation process requires that you specify one of two security
schemes to use when running SunVTS. The security scheme you choose must be
properly configured in the Solaris OS for you to run SunVTS. For details, refer to the
SunVTS User's Guide.
SunVTS software features both character-based and graphics-based interfaces. This
procedure assumes that you are using the graphical user interface (GUI) on a system
running the Common Desktop Environment (CDE). For more information about the
character-based SunVTS TTY interface, and specifically for instructions on accessing
it by tip or telnet commands, refer to the SunVTS User's Guide.
SunVTS software can be run in several modes. This procedure assumes that you are
using the default mode.
Description
SunVTS framework
SunVTS framework (root)
SunVTS for tests
SunVTS man pages
Section 3.8.1,
3-48.
Chapter 3 Server Diagnostics 3-49