Scan Operation; Scan Types; Com Band Scan; Memory Scan - Icom IC-A24E Instruction Manual

5

SCAN OPERATION

Scan types

■
The transceiver has 2 scan types to suit your needs.

COM BAND SCAN

108.000 118.000
MHz MHz

MEMORY SCAN

non-TAG channel
Mch 2 Mch 4
Mch 1
Mch 19 Mch 10
16
Repeatedly scans
136.9917
MHz
all frequencies
over the enti re
Scan
COM band.
Jump
Repeatedly scans all se-
lected memory BANK's
Mch 6
"TAG" memory channels.
Used for checking often-
Mch 7
used channels and bypass-
non-TAG
channel ing usually busy channels
Mch 8
such as control-tower fre-
quencies.
COM band scan
■
q Push [CLR•DEL] to select the frequency mode.
w Push [SQL], then rotate [DIAL] to set the squelch level to
the point where noise is just muted.
e Push , then push [ANL•
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, rotate [DIAL].
r To stop the scan, push [CLR•
Memory scan
■
q Push [MR• ] to select the memory mode.
MW
• Push , then push [0•
BANK
BANK number, if desired. Push [CLR•
lection mode.
w Push [SQL], then rotate [DIAL] to set the squelch level to
the point where noise is just muted.
e Push , then push [ANL•
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, rotate [DIAL].
r To stop the scan, push [CLR•
NOTE: Program 2 or more memory channels to start the
memory scan.
] to start the scan.
SCAN
].
DEL
], and rotate [DIAL] to select the
] to exit the BANK se-
DEL
] to start the scan.
SCAN
].
DEL