Table of Contents
Advertisement
TOUR Notes
Master Dimmer
Red, Green, Blue, &
White Color
Selection
Color Macros
Strobe
Auto
Dimmer Speed
ID Address
Selection
COLORado™ 1 IP User Manual Rev. 01c
These notes intent to clarify the way the TOUR DMX personality works.
• Channel 1 controls the intensity of the currently projected color.
• When the slider is at the highest position (255) the intensity of the output is at its
maximum.
• Channels 2, 3, 4, and 5 control the intensity ratio of each of the Red, Green, Blue,
and White LEDs.
• When the slider is at the highest position (255), the intensity of each color is at its
maximum.
• You can combine channels 2, 3, 4, and 5 to create over four billion colors.
• Channel 6 selects the required Color Macro.
• Channel 6 has priority over channels 2, 3, 4, and 5.
• Channel 1 controls the intensity of the Color Macro.
•
Channel 7 controls the strobe frequency (not the intensity) of channels 2~6.
•
Channel 7 strobes channels 2, 3, 4, and 5 when not running macros, allowing the
individual faders (R, G. B, and W) as well as channel 1 (D) to control the output
intensity.
•
Channel 7 strobes channel 6 when running macros, allowing channel 6 to select
the macro and channel 1 to control the output intensity.
• Channel 8 selects the preset auto programs AT. 01~10 or the custom programs
CUS. 01~10.
• When activating the custom programs CUS. 01~10, it is possible to control the Step
Time and Fade Time using channels 2 and 3 respectively.
• Channel 8 has priority over channels 2, 3, 4, 5, 6, and 7.
• Channel 10 is for selecting the dimmer mode and speed. When Dimmer is set to
Off, the Red, Green, Blue, White, and Dimmer outputs are linear with the faders.
Otherwise, Dim1 is the fastest dimmer curve, while Dim4 is the slowest.
• Channel 11 selects the target ID address.
• Each independent DMX address may have up to 66 independent ID addresses.
• Setting channel 11 to 0 activates all ID address locations.
Operation
-13-
Advertisement
Table of Contents
