Mounting; Orientation; Rigging - Chauvet COLORado 1 IP User Manual

Setup

Mounting

Orientation

Rigging

Procedure
Product Mounting
Diagram
-8-
Before mounting this fixture, read and follow the safety recommendations indicated in
the Safety Notes section (page 2 of this manual).
Always mount this fixture in any safe position while making sure that there is adequate
room around it for ventilation, configuration, and maintenance.
Make sure to mount this fixture away from any flammable material as indicated in the
Safety Notes section.
The COLORado™ 1 IP consists of a sealed (IP66) housing with a double bracket
mounting yoke. It has two DMX signal cables (DMX In/DMX Out), and two power cables
(Power In/Power Out), all of them fitted with proprietary IP66 connectors.
CHAUVET® recommends following the general guidelines below when mounting the
COLORado™ 1 IP.
•
When selecting an installation location, consider ease of access to the fixture for
operation, programming adjustments, and routine maintenance.
•
If hanging this fixture, make sure that the location where you are mounting the
fixture can support its weight. Please see the Technical Specifications section of this
manual for the weight requirement of this fixture.
The COLORado™ 1 IP includes a safety cable and a mounting yoke to which you can
attach one or two rigging clamps. You must supply your own "C" or "O" clamps and
make sure that they are capable of supporting the weight of this fixture. Although it is
possible to use a single clamp per fixture, CHAUVET® recommends using two clamps
per fixture. Secure the fixture with the safety cable after mounting it to the truss.
Overhead Mounting
C clamp
(not included).
Floor Mounting
Secure the safety cable using
the passageway on the back
of the fixture.
COLORado™ 1 IP User Manual Rev. 01c