Cs1764 A Cable Connections - ATEN CS1762 User Manual

CS1764 Cable Connections
A
To set up your CS1764
following page (the numbers in the diagrams correspond to the steps, below),
and do the following:
1. Plug your USB keyboard and USB mouse into the USB console ports
located on the unit's rear panel.
2. Plug your console monitor into the DVI console port located in the unit's
rear panel and power on the monitor.
3. Plug your main microphone and speakers into the console microphone and
speaker jacks located on the unit's front panel. The microphone and
speakers plugged into this panel have priority over those in the rear panel.
4. Plug your secondary microphone and speakers into the console audio ports
located on the unit's rear panel.
5. Using a KVM cable set (provided with this package), plug the DVI
connector into any available DVI socket in the KVM port section of the
switch, then plug the accompanying USB, microphone and speaker
connectors into their corresponding USB, microphone, and speaker
sockets.
Note: Verify that all the plugs are in the same KVM Port sockets (all in
Port 1, all in Port 2, etc.), and that each socket is marked with an
appropriate icon to indicate itself.
6. At the other end of the cable, plug the USB, video, microphone, and
speaker cables into their respective ports on the computer.
7. Plug your USB peripherals into the type A sockets in the USB hub section.
8. Plug the power adapter that came with your switch into an AC power
source, then plug power adapter cable into the switch's Power Jack.
9. Turn on the power to the computers.
installation, refer to the installation diagram on the
A
Chapter 2. Hardware Setup
13