S
S
UPER
ERVER 6016T-URF4+/6016T-NTRF4+ User's Manual
Accessing the Drive Bays
SATA Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace the SATA drives.
Proceed to the next section for instructions.
DVD-ROM Drive: For installing/removing a DVD-ROM drive, you will need to gain
access to the inside of the 6016T-URF4+/6016T-NTRF4+ by removing the top cover
of the chassis. Proceed to the "DVD-ROM Drive Installation" section later in this
chapter for instructions.
Note: Only a "slim" DVD-ROM drive will fit into the 6016T-URF4+/6016T-
NTRF4+.
Warning! Enterprise level hard disk drives are recommended for use in
Supermicro chassis and servers. For information on recommended HDDs,
!
visit the Supermicro Web site at http://www.supermicro.com/products/nfo/
storage.cfm
Figure 6-2. System Cooling Fans
6-4