Table of Contents
Advertisement
5-8
Connector Defi nitions
ATX Power Connector
The primary ATX power supply con-
nector meets the SSI EPS 12V speci-
fi cation. Make sure that the orientation
of the connector is correct. See the
table on the right for pin defi nitions.
Processor Power Connectors
JPW2 and JPW3 must also be con-
nected to the power supply to provide
power for the processor(s). See the
table on the right for pin defi nitions.
Warning: To prevent damage to your power supply or serverboard, please
use a power supply that contains a 24-pin and two 8-pin power connec-
tors. Be sure to connect these power connectors to the 20-pin and the two
!
8-pin power connectors on your serverboard for adequate power supply to
your system. Failure to do so will void the manufacturer warranty on your
power supply and serverboard.
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20
of JF1. Refer to the table on the right
for pin defi nitions.
Power LED
The Power LED connection is located
on pins 15 and 16 of JF1. Refer to the
table on the right for pin defi nitions.
Chapter 5: Advanced Serverboard Setup
ATX Power 24-pin Connector
Pin Defi nitions
Pin# Defi nition
13
+3.3V
14
-12V
15
COM
16
PS_ON
17
COM
18
COM
19
COM
20
Res (NC)
21
+5V
22
+5V
23
+5V
24
COM
Processor Power
Pin Defi nitions (JPW2/JPW3)
Pins
1 through 4
5 through 8
NMI Button
Pin Defi nitions (JF1)
Pin#
Defi nition
19
Control
20
Ground
Power LED
Pin Defi nitions (JF1)
Pin#
Defi nition
15
Vcc
16
Control
5-15
Pin # Defi nition
1
+3.3V
2
+3.3V
3
COM
4
+5V
5
COM
6
+5V
7
COM
8
PWR_OK
9
5VSB
10
+12V
11
+12V
12
+3.3V
Defi nition
Ground
+12V
Advertisement
Table of Contents
