Binatone SYMPHONY 2610 System User Manual page 61

Troubleshooting
"My call was cut Move the handset closer to the base unit before you try
off when I went again to make a call.
out of range.
Now I can't use
my handset."
"There is inter- Move the handset closer to the base unit, or to a
ference and different position.
noise on the
Try moving the base unit so that it's not near other
line."
electrical equipment, such as a television or a
computer.
You'll get the best results if you site the base unit as
high as possible. For example, in a two-storey house,
the first-floor landing is an ideal place for the base unit.
"I hear 'beeps' You may be going out of range of the base unit. Move
from my closer, or your call may be cut off.
handset while
Check the Battery Level symbol on the display. If it's
I'm on a call."
low, recharge the batteries.
"The handset's Check that the base unit's mains power adapter is
display shows plugged in and power is switched on.
Searching
"
Move the handset closer to the base unit.
If you have a new handset, not supplied as part of your
original Symphony 2610 system, you need to register it
to the base unit (see page 28).
If the batteries have become completely run down (or if
the handset is switched off) and you place the handset
in the charging cradle, it may take about 5 minutes to
link with the base station. Wait and try again.
58
http://www.binatoneonline.com/